Paint KBS High Temp & Brakes | Kbs Xtc Xtreme Temp Coating 340G Aluminium Aerosol Spray Paint Heat Resistant 812°C

About Kbs Xtc Xtreme Temp Coating

Xtreme Temperature Coating From Kbs Is A High Temperature / Heat Resistant Coating Formulated Specifically To Protect Metal Surfaces Operating At Temperatures From 260°C – 812°C. With Proper Preparation, Xtreme Temperature Coating Provides Outstanding Adhesion, Film Integrity, Corrosion, Weathering And Thermal Shock-Resistance Throughout This Entire Temperature Range, And Is Guaranteed Not To Burn Off!

Also Available Xtc Zinc Primer To Prime Bare Metals For Added Performance And Longevity.

Key Features

• Withstands Continuous Temperature Of Up To 812°C.
• Outstanding Heat And Weathering Resistance.
• Will Not Peel, Flake, Or Chalk.
• Long Lasting.
• Dries To Touch In 15 Mins.
• Resistant To Scratching & Marring.
• Can Be Brushed Or Sprayed.
• Resists Rust.

Note: Coverage Is Approx. 7Sqm Per Liter At 25 Micron Thickness. It Can Be Rolled And Brushed, But With High Temp Paint, Thickness Is Critical – Too Thick And The Paint Will Blister. Spraying Is The Recommended Application Process As You Are Able To Easily Ensure Coating Thickness Is Optimal.

Instructions

To Ensure Optimum Long-Term Coating System Performance, Steel Surfaces Must Be Dry And Free From Dirt, Oils, Rust, And Other Contaminants.

The Ideal Surface Preparation Is Abrasive Sand Blasting Which Ultimately Leaves The Desired Anchor Pattern For Proper Adhesion. Using Glass Beads Or Non-Abrasive Medias Is Not Recommended As These Medias Tend To Leave The Surface Too Smooth For Proper Adhesion. If Not Sandblasting, Prepare Surface By Using Stainless Steel Or Nylon Wire Wheel, Wire Brushing, Or Abrasive Sanding Using 60-80 Grit Paper. This Method Will Provide A Surface Equivalent To That Provided By Sandblasting And Allow The Desired Surface Profile (Anchor Pattern).

Kbs Xtc Xtreme Temperature Coating May Also Be Applied By Conventional Or Hvlp Spray, Airless Spray, Brush Or Roller. Do Not Apply Hi-Temp In Heavier Films Than Specified Since Blistering May Occur. For Maximum Corrosion Protection, Metal Surfaces Should Be Primed With Kbs Xtc Zinc Primer Our Silicone Zinc Dust, Heat, And Corrosion Resistant Primer (25Um), Then Topcoated With One Coat (35-50Um) Of The Xtc Color Of Your Choice.

If Not Using Kbs Xtc Zinc Primer, Apply Two Coats (35Um Each) Of Xtc Xtreme Temp Coating Allowing At Least 8 Hours Between Coats And Allow The Second Coat To Dry At Least 8 Hrs Before Subjecting Surface To Any Heat.