Die Blaster ®

• Removes Rust And Sealants In Areas That Are Difficult To Reach (E.G. Door Skins, Roof Joints, Window Channels And Wheel Housings)
• Patented Accelerator Bar Increases The Striking Energy Of The Bristles
• Creates A Rough, “Blasted” Surface
• Metallically Bright And Thorough Cleaning Of The Surface
• Special Tool For Areas That Are Difficult To Reach
• Special Range Of Belts For Joints, Recesses And Channels

The Die Blaster® Is Specifically Designed For Thoroughly Removing Corrosion From Car Body Panels, In Hard To Reach Areas.

The Die Blaster®, With Its Patented Accelerator Bar, Is Specifically Designed To Remove Corrosion In Areas That Are Difficult To Reach, Such As Door Skins, Roof Channels And Wheel Housings, Leaving A Clean (Not Polished) Rough, “Blasted Surface”.

Technical Specifications

Length – 300Mm
Width – 125Mm
Weight – 1.1Kg

Belt Diameter (Outer) – 110Mm
Required Flow Pressure – 90 Psi
Average Air Consumption – 0.4M^3/Min
Idle Speed (+- 5%) – 2700 Rpm
Threaded Air Inlet – 1/4″
Required Hose Diameter (Interior) – 3/8″
Vibration – 1.45M/Sec^2
Sound Pressure Level – 84Db

Die Blaster® Set Includes:

• Die Blaster® Drive Unit Pneumatic
• Accelerator Bar For Die Blaster®
• Adapter System 11 Mm
• Swivel Connector
• Air Pressure Regulator For Die Blaster®
• 2 Die Blaster® Belts, 11 Mm
• 2 Die Blaster® Belts, 11 Mm, Right
• 2 Die Blaster® Belts, 11 Mm, Left
• Monti Blow Mould Case